Honey's Roofing, LLC

- Remove existing shingles down to the deck. - Any bad or rotten decking will be replaced up to 5 sheets at no additional cost, any additional will be $50/sheet extra. - Install ice and water shield along all valleys. - Install new lead plumbing ventilations. - Replace existing RVG Vents with new ones painted to match. - Install synthetic underlayment to manufacturers specifications. - Install 2"x2" painted metal edging along perimeter. - Install 30-year, dimensional shingles (clients' color choice) using 1 roofing nails. - Clean up and haul off all job-related debris. - Includes a 30-year lifetime limited manufacturer's warranty on shingles. - Includes a 3-year Honey's Roofing workmanship warranty. - Crews will maintain safety requirements at all times during the construction process. ***Honey's Roofing will provide all labor, material, tools, permits (if applicable), equipment, and insurance to perform the job to the standards of the industry. ***

Scope of Work: Flat Roof System: Mule-Hide 60mil TPO single-ply, insulation board Roof Field Area: Approx. 8,000 square feet including interior parapet walls and waste $67,975.00 Scope Includes: 1.) PREP ROOFS FOR INSTALLATION OF NEW MULE-HIDE 60MIL SINGLE-PLY TPO ROOF SYSTEM. BUILT-UP ROOF SYSTEM AND METAL ROOF TO REMAIN. 2.) @ BUILT UP ROOF SECTION, MECHANICALLY FASTEN A EPS FANFOLD INSULATION OVER EXISTING BUILT-UP ROOF AND IN TO EXISTING CONCRETE DECK WITH MULE-HIDE REQUIRED COATED FASTENERS. WHEN RUNNING FASTENERS IN TO CONCRETE DECK, THERE IS A POSSIBILITY OF THE INTERIOR UNDERSIDE OF CONCRETE DECK TO SPORE OR LOSE PIECES OF CONCRETE WHERE SCREW PENETRATES. THIS CAN BE UNSIGHTLY TO SOME VISUALLY AND MUST BE APPROVED BY BUILDING OWNER PRIOR TO PROJECT START. 3.) @ METAL ROOF SECTION, INSTALL AN EPS FLUTE FILLER IN BETWEEN RIBS OF METAL ROOF, FOLLOWED BY INSTALLATION OF A 1 POLYISO INSULATION BOARD, MECHANICALLY FASTENED. 4.) MECHANICALLY FASTEN A WHITE, 60MIL SINGLE-PLY MULE-HIDE TPO ROOF SYSTEM AT A FASTENING RATE OF 12 O/C IN THE FIELD AND 6 O/C IN PERIMETERS AND CORNERS WITH MULE-HIDE REQUIRED COATED FASTENERS. INCLUDES ALL PIPES, PENETRATIONS, CURBS AND SPECIFIED INTERIOR PARAPET WALLS TO BE WRAPPED IN MULE-HIDE 60MIL TPO. 5.) INTERIOR PARAPET WALLS ABOVE 18 IN INTERIOR HEIGHT WILL BE FULLY ADHERED WITH MULE-HIDE TPO BONDING ADHESIVE PER MANUFACTURER REQUIREMENTS. 6.) TERMINATE TO OUTSIDE PERIMETER EDGE WITH A 24GA SHOP FABRICATED PREFINISHED SNAP-ON COVER (COLOR OPTIONAL AMONGST STANDARD COLOR CHOICES). INCLUDES INSTALLING TPO PITCH PANS AND TPO PIPE BOOTS WITH CLAMP RINGS TO SPECIFIED PENETRATIONS. TERMINATE AND FLASH TPO TO EXISTING HVAC CURBS WITH SHOP FABRICATED A/C CURB FLASHING AND 1 TERMINATION BAR, BACKSEALED PERMANUFACTURER REQUIREMENTS. 7.) INCLUDES 25 YEAR MANUFACTURER MATERIAL AND LABOR NDL WARRANTY (MULE-HIDE PRODUCTS). A MULE-HIDE REPRESENTATIVE/INSPECTOR WILL PERFORM A FULL INSPECTION OF ROOF ONCE PROJECT APPLICATION IS COMPLETE. 8.) INCLUDES HONEYS ROOFING 15YR WORKMANSHIP WARRANTY (NO CHARGE). 9.) DISPOSE OF ALL TRASH AND DEBRIS IN AN APPROVED FACILITY IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS. 10.) INCLUDES ALL WORKER COMPENSATION AND GENERAL LIABILITY INSURANCE. 11.) INCLUDES ALL LIFT/LOAD EQUIPMENT NEEDED TO PERFORM JOB ACCORDINGLY.